The SynergyF4 was designed as an upgrade to your standard F4 flight controller with a focus on cleaner and easier building. A TBS Unify Pro V3 or a Unify Nano can be directly mounted to the surface of the board with no tape or zipties required. In addition, the FrSky XM+ and TBS Crossfire Nano can be directly mounted to the board for a quick and easy build process.

Solder bridge selectors on the bottom of the board allow for a wide range of components to be used with the FC.

Note: This FC is compatible with any receiver and video transmitter. Simply connect the rx/vtx with wires to the correct pads.

SPECIFICATIONS

Processor: STM32F405 (F4 processor)
Gyro: MPU6000
Loop: 8k/8k
Input: 2-6S (Max 28V)
Regulator: Filtered 5V 3A
Receiver: 3.3V or 5V selectable. Inverted and non-inverted selectable receiver input.
Connectors: 8 pin JST-SH main connector. 2x 3 pin JST-SH Addressable LED connectors (mirrored output)
Telemetry: Current Sensor and ESC Telemetry Input
Blackbox: 128Mb flash
Motor: 4 pwm motor outputs with D-Shot and Multishot support.
Mounting: M3 30.5x30.5mm holes with soft mounting
Dimensions: 37x37mm
Weight: 7.5g
Camera: Filtered 5V output

FEATURES

Direct mounting for Unify Pro (5V) and Unify Nano (with adapter).
Header holes for direct receiver installation.
Built in camera control via single wire (analog only)
Built in BetaflightOSD
Buzzer: Dedicated pads for 5V (100mA max) buzzers.
Onboard addressable LED.
Built in Tiny’s LEDs RealPit VTX power switch (selectable between ON-OFF-Remote)
Receiver can be powered on via USB (VTX stays off)
SmartAudio: Selectable between internal (FC controlled) and external (receiver).
UART1: Receiver (FrSky, Spektrum, Crossfire, etc).
UART3: SmartAudio (or any other desired output if SmartAudio is selected to pull signal at the “external” pad, designated RX SA on the top of the FC).
UART6: ESC Telemetry (if applicable) or UART Cam control

HQ Prop Battery Straps (2pcs)